➊ Motor FLA
rating must fall within the specified current range for unit to operate
properly. The overload setting must be set to the motor FLA regardless if the
Overload
Function is
“OFF” disabled.
➋ See page
D23 for maximum starts per hour.
➌ Prior to
the initial start of the motor at the final installation location:
– The bypass
relays on the main circuit may be in an undefined switching state due to
handling during shipping. Before connecting the main power source, apply the
control
voltage to set the bypass relays to a defined switching state. If this step
is not performed, inadvertent operation of the motor may occur.
➍ Separate
120V or 240V single phase is required for PCS fan operation.
➎
Controllers rated 108A and greater are not equipped with the line and load
terminal lugs. See page D18 for terminal lug kits.
Open Type Controller - Line connected➊➎
Rated
Voltage [V AC]
Motor Current
(Amps) ➋
Max. kW 50
Hz
Max. Hp 60 Hz
➌
100...240V AC
50/60Hz Control Voltage Catalog Number