|
1418 Series Single Door Freestanding Enclosures - NEMA 12
Single or Dual Access
Application
- Designed to house electrical, electronic, hydraulic or
pneumatic controls with provision for panel mounting or rack mounting
of equipment.
- Provides a degree of protection from falling dirt, dust, oil and water.
- Available with front access only or both front and rear access.
- A variety of inner panels, rack mounting rails and swing
out frames are available to provide flexibility in mounting
arrangements.
Standards
- UL 508 Type 12
- CSA Type 12
- Complies with
- NEMA Type 12
- IEC 60529, IP54
Construction
- Formed 12 gauge steel.
- Smooth, continuously welded seams without knockouts, cutouts or holes.
- Lifting eyes provide for easy enclosure handling.
- Doors are supported with heavy gauge continuous hinges.
- Doors are secured with a three point latch and operated with a key locking automotive type handle.
- Latch rods are equipped with rollers for easier door closing.
- Oil resistant gaskets are permanently secured and mechanically retained.
- Mounting channels are welded on the inside of the enclosure for mounting of optional inner panels or rack equipment rails.
- A grounding stud is provided in the enclosure and a bonding stud is provided on the door.
- A literature pocket is provided for the inside of the door (Two pockets are provided for dual access units).
Finish
- Cover and enclosure are finished in recoatable smooth
ANSI 61 gray powder coating on the outside, with white powder coating
on the inside.
- Optional inner panels, rails, frames and supports are finished in white powder coating.
Accessories
- Air conditioners
- Blowers
- Breather Kits
- Door Stop Kits
- Drip Shield Kits
- Filter Fans
- Floor stand kits
- Gland plates
- Heaters
- Inner panels
- Light kit
- Louvered Ventilating Plates
- Swing Frame
- Thermostats
- Window kits
|
