|
AC Current Transducer
TCSA Series
Loop Powered
The TCSA Series is a loop powered, linear output current transducer that provides an output that is directly proportional to the RMS AC current passing through the onboard toroid. The TCSA provides a 4 to 20 mA output over a power supply range of 10 to 30 V DC. Each unit is factory calibrated for monitoring from 0 to 5, 0 to 10, 0 to 20, or 0 to 50 A in four ranges. The 0 to 5 A range allows the use of external current transformers so loads up to 1200 AC amps can be monitored. 
-
Monitors 0 - 50 A in 4 Ranges
-
Loop Powered from 10 - 30 V DC
-
Linear Output from 4 - 20 mA
-
Zero and Span Adjustments
-
Complete Isolation Between Sensed Current and Control Circuit
AC Current Transducer
DCSA Series
Loop Powered
The DCSA Series is a loop powered, linear output current transducer that provides an output that is directly proportional to the RMS AC current passing through the LCSC10T12 sensor. The DCSA provides either an analog current or voltage: 4 to 20 mA, 1 to 5 V DC, or 2 to 10 V DC. Each unit is factory calibrated for monitoring (with the LCSC10T12 connected) from 0 to 5, 0 to 10, 0 to 20, or 0 to 50 A in four ranges. Zero and span adjustments allow field calibration if needed. The DCSA mounts on both DIN 1 and DIN 3 rails. 
-
Mounts on DIN 1 or DIN 3 Rail
-
0 - 50 A in 4 Ranges using LCSC10T12 Sensor
-
Loop Powered from 10 - 30 V DC
-
Linear Output from 4 - 20 mA, 1 - 10 V DC
-
Zero and Span Adjustments
-
Separate Sensor & Control Unit
|
|
